7
PREPARATION & SETUP
WARNING!
Failure to unplug your random orbital sander could result in
accidental starting causing possible serious injury.
Sanding Sheet Installation
Your random orbital sander is equipped with a hook and loop backing pad (6).
This uses hook and loop technology, which firmly grips the sanding sheets when
applied with moderate pressure.
1. To change, merely peel off the old sanding
sheet, remove dust from the hook and loop
backing pad (6) if necessary, and press the new
sanding sheet in place.
2. Be sure to align the sanding sheet holes with
the holes in the hook and loop backing pad
(6). This allows the dust extraction system to
function effectively (Fig. 1).
After considerable use, the hook and loop backing pad (6) surface will become
worn, and must be replaced when it no longer offers a firm grip. If the hook and
loop backing pad (6) facing is wearing prematurely, decrease the amount of
pressure applied during operation of the sander. Damage to the hook and loop
backing pad (6) is not covered by the warranty.
Note:
Please refer to the maintenance section (page 12) for backing pad
replacement procedure.
Dust Bag
The dust extraction system extracts sanding dust from the work piece through the
holes in the hook and loop backing pad (6). The dust is then transferred through
to the dust extraction port on the rear of the sander housing. To capture this
dust, it is best to attach the dust bag (4).
1. To attach the dust bag (4) simply push the dust
bag into the dust extraction port on the rear of
the sander housing (Fig. 2).
2. To remove the dust bag (4), simply pull the
dust bag out of the dust extraction port.
Note:
For the dust bag (4) to work at its optimum level, empty when it becomes
1/3 full. This allows air to flow through the bag freely, increasing its effectiveness.
!!
Fig.1
Fig. 2
Summary of Contents for OZRO450A
Page 1: ......