Connecting The Compressor To A Car Battery
1. Ensure the on/off switch is in
the off ‘0’ position.
2. With the car engine running,
connect the red battery
terminal clamp to the positive
(+) pole on your vehicle
battery.
3. Connect the black battery
terminal clamp to the negative
(-) pole on your vehicle
battery.
Disconnecting The Compressor From The Power Source
1. Turn off the air compressor by flipping the on/off switch to the off ‘0’
position.
2. Remove the black battery
terminal clamp from the
negative (-) pole of your
vehicle battery.
3. Remove the red battery
terminal clamp from the
positive pole (+) of the vehicle
battery.
Starting The Air Compressor
1. To turn on the air compressor,
press the on/off switch to the ‘I’
position.
Note:
You may experience a slight
delay (approximately 0.5 seconds)
between the on/off switch being
flipped and the motor unit turning on.
This is a normal function while the
compressor pressurises the air in the hose.
2. To turn the unit off, press the on/off switch to the ‘0’ position.
Inline Fuse Protection
The air compressor is equipped with a 30A fuse between the unit and
the clamps. This feature is designed to protect you and the unit from
excessive current surges. If the fuse breaks during use, follow the
steps below to replace it.
1. Flip the on/off switch to the off
position, disconnect the black
clamp and then the red clamp
from the battery.
2. Flip open the lid on the fuse
housing. Remove the old fuse
and replace it with the supplied
replacement.
3. Replace the fuse housing lid.
WARNING!
DO NOT CONTINUE USE OF THE UNIT IF
THE FUSE BREAKS AGAIN ON USE IMMEDIATELY
AFTER BEING REPLACED. THERE MAY BE A FAULT
WITH THE UNIT; CONTACT OZITO CUSTOMER
SERVICE.
In-Line Pressure Gauge
The in-line pressure gauge allows you to
conveniently monitor the air pressure in
the object during inflation/deflation without
needing to change between accessories.
Note:
You will need to momentarily halt
inflation/deflation in order to obtain accurate
pressure readings as air flowing in the hose
may throw off the readings.
2. APPLYING A POWER SOURCE
3. CONTROLS
OPERATION
+
-
+
-
a.
b.
+
-
ON
OFF
ON
OFF
a.
b.
0
25
50
75
100
125
150
0
(1)00
(3)00
(5)00
(7)00
(9)00
2
4
6
8
10
Lb/in²
(PSI)
kPA
(BAR)
PRESSURE GAUGE
kg/cm²
WARNING!
KEEP THE VEHICLE ENGINE RUNNING
WHILE USING THE AIR COMPRESSOR TO
PREVENT DISCHARGING THE VEHICLE BATTERY
COMPLETELY.
WARNING!
ONLY USE THE AIR COMPRESSOR IN
WELL VENTILATED AREAS.
WARNING!
ENSURE THE POWER CORD IS
UNCOILED AND FULLY EXTENDED TO AVOID
OVERHEATING THE POWER CORD. ENSURE
THAT IT DOES NOT GET TANGLED OR CAUGHT
IN ANY ROTATING PARTS WITHIN THE ENGINE
COMPARTMENT OF THE VEHICLE.
