MAINTENANCE
DESCRIPTION OF SYMBOLS
WARNING!
BEFORE CLEANING YOUR TOOL, MAKE
SURE THAT THE POWER SUPPLY HAS BEEN
REMOVED OR DISCONNECTED TO PREVENT
ACCIDENTAL STARTING.
Warning
Regulatory Compliance Mark
(RCM)
V
Volts
%RH
°F
Percent Relative Humidity
°C
Degrees celsius
Degrees Fahrenheit
Read Instruction Manual
Power tools that are no longer usable should not be
disposed of with household waste but in an environmentally
friendly way. Please recycle where facilities exist. Check
with your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution in
the environment. Please recycle packaging where facilities
exist. Check with your local council authority for recycling
advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
Cleaning
Clean the appliance regularly with a soft, dry cloth. Do not use
cleaning agents or solvents; these may be aggressive to the plastic
parts in the appliance. Ensure that no water can get into the interior of
the appliance.
Calibration
A standard sound source which outputs 94dB, 1kHz sine waves
should be used to calibrate the unit. You will need a calibrator (not
supplied) to perform this task. It is recommended that calibration of
the meter is carried out once a year.
1. Remove the windshield if it is
attached.
2. Press and hold down the ‘FAST |
SLOW’ and ‘MAX | MIN’ buttons.
3. Then press the power button until the
backlight flashes briefly.
Note:
‘CALI’ will appear on screen once
the meter has entered the calibration
mode.
4. Follow the manufacturer’s instructions for using your calibrator.
5. Press the ‘BACKLIGHT | HOLD’
button to start calibrating the unit. The
display will start flashing.
6. After 2 seconds, calibration is
complete and the meter will switch off
automatically.
Storage
Switch off the tool, place it in the storage bag and store it in a dry
location which is not accessible to unauthorised persons.
Remove the batteries before storage if the tool will not be in use for a
long time.
DIGITAL SOUND
LEVEL METER
HOLD
SLOW
FAST
MIN
MAX
SLOW
H
dBA
DIGIT
AL SOUND
LEVEL METER
HOLD
SLOW
FAST
MIN
MAX
FAST
H
MAX
dBA
DIGITAL SOUND
LEVEL METER
HOLD
SLOW
FAST
MIN
MAX
PRESS
&
HOLD
1.
1.
2.
