NSG-5000
4. OPERATING THE NAIL GUN
5. TROUBLESHOOTING
1. Push the power switch to
the “I” position.
4. Push the tool firmly
down on the work
surface to depress
the safety striker pin.
3. Place the staple
nail gun against the
work surface so that
the nosepiece of the
tool is where you
want the staple/nail
to be located.
5. Squeeze the trigger
switch to fire a
staple/nail.
NOTE:
The on/off trigger cannot be squeezed unless the safety
striker pin is fully depressed.
Clearing Jammed Nails/Staples
2. Remove the two
plates from the front
of the gun.
1. Remove the three
screws on gun
head.
3. Remove any staples
or nails that may be
causing the jam.
Clear any
jams
2. Set the variable depth
adjustment dial.
4. Reassemble the nail gun. Be sure
not to lose the square plastic cap.
If you reassemble the nail gun
without this piece, the safety
striker pin will not depress and
the gun will not fire.
Ensure the tool is disconnected from the power supply
before performing any of the following operations.