Shaping
A hedge should be trimmed to a trapezoidal form, that is, it should widen toward the
bottom at both sides. This improves the penetration of light to the lower extremities.
A general guideline is approximately a 10cm slant for each 1 metre of hedge height.
Cutting sequence
First cut both sides, starting at the bottom and work to the top to prevent cuttings
from falling into the area where you are still working.
Trimming the top
Where the branches have grown extremely long, cut back the hedge in several stages.
The shorter the cuttings the better suited they are for composting.
General information
When older hedges are to be cut back a substantial amount, use pruning shears or
some other device to trim thicker branches (greater than 15mm diameter) to the
desired length before starting work with the hedge trimmer.
To shape precisely, run a taught line between the extreme edges of the hedge and
then trim along the length of the line.
Ensure the dual action cutting blades (8) do not come into contact with any object
made of hard material that could damage the blades, such as fencing wire or metallic
plant supports.
When the task is complete, turn off the tool, remove the battery (9) and slip on the
blade cover (12).
•
When not in use, the tool should be stored in a dry, frost-free location, out of reach
of children.
•
Keep ventilation slots of the trimmer clean at all times and prevent any foreign
matter from entering.
•
If the housing of the trimmer requires cleaning, do not use solvents but a moist
soft cloth only.
•
The blade rail should be cleaned and treated with light machine oil or spray
lubricant (such as WD40, CRC 5.56 or RP7) after each use. The lubrication will also
help prevent corrosion of the blade when not in use. When a job lasts for a longer
period of time it is recommended that the blade rail also be treated with spray
lubricant at regular intervals during operation.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or by mishandling of the tool.
The blades are not covered by warranty - any damage to or sharpening of the blades
is the responsibility of the user. Use of the hedge trimmer with blunt blades will place
excessive load on the motor and gearbox. Ozito Industries cannot accept warranty
liability for damage caused by lack of maintenance to the hedge trimmer.
13
OPERATION (cont.)
MAINTENANCE
Summary of Contents for LHT-018
Page 1: ......
