MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep the ventilation vents of the mini blower clean at all times, if possible,
prevent foreign matter from entering the vents.
• After each use, blow air through the mini blower housing to ensure it is free
from all dust particles which may build up. Build up of dust particles may
cause the mini blower to overheat and fail.
• If the enclosure of the mini blower requires cleaning, do not use solvents but
a moist soft cloth only. Never let any liquid get inside the mini blower; never
immerse any part of the mini blower into a liquid.
Carbon Brushes
When the carbon brushes wear out, the mini blower will spark and/or stop.
Discontinue use as soon as this happens. They should be replaced prior
to recommencing use of the mini blower. Carbon brushes are a wearing
component of the mini blower therefore not covered under warranty. Continuing
to use the mini blower when carbon brushes need to be replaced may cause
permanent damage to the mini blower. Carbon brushes will wear out after many
uses but when the carbon brushes need to be replaced, take the mini blower to
an electrician or a power tool repairer for a quick and
low cost replacement. Always replace both carbon
brushes at the same time.
Note: Ozito Industries will not be responsible for any
damage or injuries caused by the repair of the mini
blower by an unauthorised person or by mishandling
of the mini blower.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents.
This is normal and does not indicate a problem.
Excessive sparking visible through the housing air vents
and/or the blower failing to operate
May indicate the carbon brushes have worn out and need to be
replaced. Carbon brushes should only be replaced by a qualified
electrician or power tool repairer.
Carbon
Brush
SPEMB2000-02
Blower Tube Assembly
SPEMB2000-22A
On/off
Switch
SPEMB2000-31
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Regulator compliance mark
V
Volts
Hz
Hertz
~
Alternating current
W
Watts
/min
Revolutions or
reciprocation per minute
Double insulated
n
o
No load speed
Warning
Read instructions
Wear eye protection
Be aware of people around you and do not direct
towards them
Keep bystanders away
SWITCH OFF: Remove
plug from mains before
cleaning or maintenance
Do not use in the rain or leave
outdoors while it is raining
