OPERATION
To obtain the desired cutting height, the front and rear axles
are repositioned on the underside of the mower housing.
1. Secure the power cord
from the switch housing to
the mower using cable ties
(supplied).
2. To assemble the grass
catcher align the two halves
and push them together, one
side at a time. Ensure the two
halves click together around
the entire middle section.
1. Assemble the grass catcher
handle onto the opening
on the top half of the grass
catcher. The handle will
click into position when
aligned and fitted correctly.
WARNING!:
WHEN ASSEMBLING THE GRASS
CATCHER BACK TO THE MOWER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD
UP OF GRASS IN THE GRASS CHUTE. IF NEEDING TO
CLEAR THE GRASS, ALWAYS ENSURE THE MOWER
IS DISCONNECTED FROM THE POWER SUPPLY
PRIOR TO CLEARING. A BUILD UP OF GRASS IN THE
GRASS CHUTE MAY PREVENT GRASS FROM MOVING
INTO THE GRASS CATCHER EFFECTIVELY.
WARNING!:
DISCONNECT THE MOWER FROM
THE POWER SUPPLY AND ENSURE THE BLADE
HAS STOPPED COASTING BEFORE ADJUSTING THE
HEIGHT.
Securing the Power Cord to the Handles
Assembling the Grass Catcher
“CLICK”
“CLICK”
“CLICK”
Fitting and Removing Grass Catcher
2. PREPARATION
Cutting Height Adjustment
3. To empty the grass catcher,
lift the catcher flap with
one hand then lift the grass
catcher with the other hand
up off the two raised housing
clips.
The catcher must be attached to the two raised hooks on the
mower.
1. Lift up the catcher flap with
one hand and guide the
catcher over the two hooks
on the mower housing.
2. Lower the grass catcher in
place and lower the catcher
flap. The catcher flap is held
against the gass catcher by
a spring
1. Place the mower on its side.
2. Pull the wheel axle towards
the front of the mower.
3. Locate the wheel axle into
the desired cutting height
adjustment position.
HOOK
Using the Cord Retainer
1. Make a loop with the
extension lead (socket end
of lead) through the loop and
secure over the hook.
2. Once fitted, connect the lawn
mower power plug into the
extension lead socket.
Note:
Make sure that front,
back, left & right wheels are
located in the same cutting
height adjustment position.
1
2
3
Cutting Height Positions
1 - 30mm (lowest).
2 - 50mm.
3 - 70mm (highest).
The cord retainer prevents the extension lead (not included)
from being disconnected during use. Only use Heavy Duty
extension lead suitable for outdoor use with electric garden
tools, no longer than 25 meters.
