ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
1. Material Support Bar
2. Material Clamp
3. Rear Fence
4. Retractable Safety Guard
5. Mitre Lock Knob
6. Movable Stop
7. Rotating Mitre Table
8. Head Locking Pin
9. Release Lever
10. On/Off Switch
11. Carbon Brush Cap
12. Operating Handle
MITRE SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
13. Hex Keys, 5 & 6mm
14. Dust Bag
Fitting the Dust Bag
2 Slide the end of the dust bag
over the dust extraction port
and release the clamp.
1 Squeeze the clamp
at the end of the
dust bag.
1. Can be mounted to the
fence, either the left or right
hand side.
Material Clamp
WARNING!
ENSURE THE SAW IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING ASSEMBLY.
2. Release cutting head from
its transport position. While
holding the head of the saw
down release the lock down
knob.
Material Support Bar
1. Insert the material support
bars into the 2 holes on either
side of the base.
Note:
Ensure they are fully
inserted.
2. Secure in place with the 5mm
hex key.
