1. Safety Release Lever
2. Carry Handle
3. Retractable Blade Guard
4. On/Off Trigger
5. Cutting Handle
6. Motor
7. Lock Down Pin
8. Bevel lock
9. Material Support Bar
10. Mounting Point
11. Fence
12. Mitre Table
13. Mitre Table Lock
14. Material Clamp
COMPOUND MITRE SAW
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
5
4
2
1
3
14
13
6
7
8
9
10
11
12
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
Unpacking
1. Remove foam packaging materials and using the carry handle,
carefully lift the mitre saw from its box and place it on a level
work surface.
2. Release cutting
head from
its transport
position. While
holding the
head of the saw
down release
the lock down
pin.
Dust Bag
1. Squeeze the clamp at the end of the
dust bag, place over the dust extraction
port.
Note:
The dust extraction port can block
easily with dust and requires to be
periodically cleaned. For more efficient
operation, empty the dust bag when it is
no more than half full. This allows better
air flow through the bag. Dust bags will not
collect all the saw dust generated by the
mitre saw. For best results a dust extractor
should be used in place of the dust bag.
Material Clamp
Material clamp will assist
securing timber when making
cuts.
The clamp can be mounted on
either the left or right.
Note:
Use the locking knobs to
secure the material clamp.
When performing a bevel or compound
cut, the material clamp should be
positioned on the right hand side of the
fence.
HOLD
DOWN
WARNING!
ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
