2. KEYLESS CHUCK
3. CONTROLS
OPERATION
CAUTION:
TO REDUCE THE RISK OF INJURY WE
RECOMMEND THE USE OF GLOVES WHEN HANDLING
DRILL BITS.
Installing a Drill Bit
Removing a Drill Bit
1 Rotate the chuck collar anti-
clockwise to open the chuck.
3 Tighten the chuck by turning
clockwise.
1 Open the chuck by rotating the
chuck collar and remove the
drill bit.
2 Insert the drill bit,
making sure it
is centred in the
chuck.
4 Pull on the bit to
ensure it is firmly
secured.
a
b
Forward / Reverse Lever
Speed Control
Adjusting Torque
Variable Speed Trigger
1 For forward rotation, push the
fwd/rev lever towards the left
side of the drill.
For reverse rotation push fwd/
rev lever to the right.
1 Slide the switch forward to
select first gear.
2 Slide the switch backward to
select second gear.
The gear selector controls the speed of the drill. First gear allows slower
drilling with more torque, while second gear is suitable when less torque
but higher speed is required.
1 Rotate the torque collar to the
desired setting.
1 To start drilling squeeze the
variable speed trigger.
2 To stop drilling release the
trigger.
FWD
REV
1st
2nd
Note:
The more the variable speed trigger is depressed, the faster the
drill bit will rotate.
Note:
Selecting a higher torque
setting will allow the drill to
use more torque to drive the
screw in or out. To prevent
damaging the screw head,
it is recommended to start
at a low torque setting and
increase when necessary.
