7
•
The longest life and best performance can be obtained if the battery pack is
charged when the air temperature is between 18 - 24ºC. Do not charge the
battery pack in an air temperature below 10ºC or above 40ºC. This is
important and will prevent damage to the battery pack.
•
Do not incinerate the battery pack even if it is seriously damaged or is
completely worn out. The battery can explode in a fire.
•
Never attempt to open the battery pack for any reason. If the plastic housing
of the battery pack breaks or cracks, immediately discontinue use and do not
recharge.
•
During charging, the battery must be placed in a well ventilated area
•
Hold power tool by insulated gripping surfaces, when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord.
Cutting accessory contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an electric shock.
•
Do not use the drill in wet or damp conditions.
•
Always keep the work area free of tripping hazards.
•
When using the drill always ensure you are wearing protective safety equipment
including safety glasses/goggles, ear muffs, dust mask and other protective
clothing including gloves and apron.
•
Always check the work piece before operation and remove any obstructions such
as nails, staples, screws, string, rags, cloths and other debris.
•
Always use clamps or a vice to hold down and secure the work piece.
•
Before drilling ensure there is a suitable gap below the work piece to prevent the
drill bit from touching any obstacles.
•
Before drilling holes or screwing into walls ensure that you are not breaking into
any electricity, gas or water supply line, etc.
•
Never change the direction of the chuck rotation while the tool is still running.
Ensure the chuck has come to a complete stop before changing the rotation of
the drill.
•
Do not lay the tool down unless the tool is switched off and the chuck has come
to a complete stop.
•
Keep hands and other body parts well away from the work area whilst the tool is in
use.
•
Keep hand well away from the under side of the work piece during use.
•
Do not use your hand to remove any dust, chips or other waste while the tool
is in use.
•
Do not touch the drill bit after operation. The bit will be HOT and burn.
BATTERY AND CHARGER SAFETY WARNINGS
!!
DRILL SAFETY WARNINGS! ADDITIONAL SAFETY RULES
!!
Summary of Contents for CDL-144
Page 1: ......
