4. CONTROLS
5. SANDING
• Check your workpiece often. The sander is capable of removing
material rapidly, especially with coarse paper.
• Do not sand on one spot for too long. The sander’s rapid action
may remove too much material, creating an uneven surface.
CAUTION:
GUIDE THE CORD DURING SANDING TO
PREVENT IT BEING CAUGHT ON THE WORKPIECE OR
OTHER OBJECTS.
WARNING!
THE POWER SUPPLY FOR THIS PRODUCT
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
2 To stop operation, release
the on/off trigger.
1 If required, secure the
material to be sanded so that
it doesn’t slip from under the
sander.
3 Press the on/off trigger and
allow the sander to reach
maximum speed.
2 Release the on/off trigger.
1 To start the sander, squeeze
the on/off trigger.
2 Firmly grip the sander
and lower the rear
heel of the sander
onto your workpiece,
with the belt off the
work surface.
4 Lower the sander onto the workpiece and use a back and forth
motion.
Note:
Do not apply pressure on the sander. Allow the sander to do the
work.
1 Squeeze the on/off
trigger then press the
lock on button.
3 To stop operation,
press and release the
on/off trigger.
On/Off Trigger
Lock On Button
BSR-7000U
The BSR-7000U is designed with a lock on button which allows you
to lock the belt sander on which helps to reduce user fatigue when
working for longer periods.
