TROUBLESHOOTING
MAINTENANCE
If the sand blasting gun fails to work effectively, perform the
following checks:
• Check the air inlet is free of any dirt or blockages.
• Ensure the gun is lubricated properly.
• Check that the pressure on the air compressor is within its
||
working range. If not, let the compressor rest to
||
re-pressurise / refer to the compressor instruction manual.
Note: This tool is rated at 90psi. Ensure your compressor is set no higher than 90psi.
• If the enclosure of the gun requires cleaning, do not use
solvents but a moist soft cloth only. Never let any liquid get inside
the gun; never immerse any part of the gun into a liquid.
• Store the tool in a dry and safe place out of reach of children.
•
Oil the sand blasting gun after each use.
CONNECTING TO COMPRESSOR
OPERATION
FILLING THE SAND BLASTING MEDIA CONTAINER
3. Screw the male nitto fitting
clockwise into the female end
of the air inlet.
4. Pull back the sleeve on hose
fitting, insert male end & release
sleeve on hose fitting.
1. Remove black plastic cap
from the air inlet.
2. Wrap the threaded male
end of an air fitting with
thread seal tape in a clockwise
direction.
2. Press the on/off trigger to start
blasting sand at the workpiece.
1. Ensure that the workpiece is secured
with clamps to avoid movement while
spraying.
2. Fill the media container with
suitable sand blasting media. Screw
the lid onto the container to secure.
1. Remove the container lid by
unscrewing in an anti-clockwise
direction.
3. To stop spraying release the
on/off trigger.
Note: Disconnect the tool from the air supply before fitting or removing attachments.
Note: The sand blasting gun must
only be used with media which
does not contain silica.
