Fitting The Air Filter
1. Remove the transportation cover from the air filter connection with
a screwdriver.
2. Attach the supplied air filter by
screwing it in clockwise.
Fitting The Oil Sealing Plug
1. Remove the transportation cover from the oil filler opening with a
flathead screwdriver.
2. Insert the oil sealing plug into
the oil filler opening.
Checking The Oil Level
1. Place the compressor on a level surface.
2. Check that the oil level is
between the the ‘MAX’ and
‘MIN’ marks on the oil level
window.
3. If the oil level is below the ‘MIN’ mark, refer to the Maintenance
section - Changing The Oil and follow the directions for refilling the
oil in the compressor.
Switching The Compressor On/Off
1. To switch the compressor on,
press the on/off switch to the
‘I’ position. Allow the motor to
run and the tank to fill up.
Note:
The compressor will automatically cut off when the tank
pressure reaches 8bar and will automatically start up again when the
tank pressure drops to 5.5bar.
2. To switch the compressor off, press the on/off switch to the ‘0’
position.
Restarting The Compressor If It Overloads & Shuts Off
The motor is fitted with an overload switch which turns off the
equipment automatically to protect the compressor from overheating.
1. If the overload switch triggers, switch off the compressor using the
On/Off Switch and wait until the compressor cools down.
2. Press the Overload Reset
Switch and restart the
compressor.
WARNING!
DO NOT CONTINUE USE OF THE
UNIT IF THE OVERLOAD SWITCH TRIPS AGAIN
IMMEDIATELY AFTER THE RESET.
2. CONTROLS
OPERATION
Max.
Min.
0
50
100
150
200
225
ON
OFF
WARNING!
THE AIR COMPRESSOR MUST BE USED
WITH A RESIDUAL CURRENT DEVICE WITH A
RATED RESIDUAL CURRENT OF 30MA OR LESS.
WARNING!
DO NOT LEAVE THE AIR COMPRESSOR
UNATTENDED WHILE THE ON/OFF SWITCH IS IN
THE ‘ON’ POSITION.