TROUBLESHOOTING
MAINTENANCE
If the air caulking gun fails to work effectively, perform the
following checks:
• Check the air inlet is free of any dirt or blockages.
• Ensure the gun is lubricated properly.
• Check that the pressure on the air compressor is within its
||
working range. If not, let the compressor rest to
||
re-pressurise / refer to the compressor instruction manual.
Note: This tool has a rated pressure of 43psi (3Bar). Ensure your compressor is set no higher than 43psi (3Bar).
• If the enclosure of the gun requires cleaning, do not use
solvents but a moist soft cloth only. Never let any liquid get inside
the gun; never immerse any part of the gun into a liquid.
• Store the tool in a dry and safe place out of reach of children.
•
Oil the air caulking gun after each use.
CONNECTING TO COMPRESSOR
OPERATION
LOADING THE CAULKING GUN
3. Screw the male nitto fitting
clockwise into the female end
of the air inlet.
4. Pull back the sleeve on hose
fitting, insert male end & release
sleeve on hose fitting.
1. Remove black plastic cap
from the air inlet.
2. Wrap the threaded male
end of an air fitting with
thread seal tape in a clockwise
direction.
2. Press the on/off trigger to start
and smoothly move the nozzle
across the gap.
1. Hold the nozzle up against the gap
you wish to seal.
2. Insert the caulking cartridge and
screw the nozzle onto the cartridge.
1. Unscrew the front cap
3. To stop caulking release the
on/off trigger and press the release
valve.
Note: Disconnect the tool from the air supply before fitting or removing attachments.
3. Screw the front cap onto the gun
and cut the end off the nozzle at
the desired caulking diameter.
