Page 4
Manual Version:
V1.0
Model Code:
4714
Oypla.com LLP
/ www.oypla.com
Operating Instructions
This heater is intended for use in outdoor open areas or in indoor well-ventilated areas. For indoor use, provide
permanent ventilation openings of at least 25cm
²
/kW, equally distributed between floor and high level, with a
minimum of 250cm
²
.
Contents
1
Front Cover
2
Safety
Instructions
4
Operating
Instructions
5
Cleaning
Instructions
7
Trouble
Shooting
8
Back Cover
Start Up
1)
Fill the tank with clean fuel. Only use Diesel or Kerosene. The fuel gauge on top of
the tank allows you to check the fuel level.
2)
Connect the power cord plug to an AC220V-240V 50Hz earthed electrical supply
system. Earthing is mandatory.
3)
When steps 1 and 2 are complete, the power indicator light will turn on. Push the
power switch to the
“
on
”
position. If the thermostat control knob is set to higher
than the ambient temperature, the electrodes start sparking. After 7 seconds, the
heater will start.
4)
If the thermostat knob is set to lower than the ambient temperature, turn it to your
desired temperature. Then, the electrodes will start sparking, and the heater will
start after 7 seconds.
-
Note:
If you are starting the heater up in cold conditions, you may place a finger over
the air vent hole (see diagram below) during ignition to make start-up easier.
-
Note:
In case of malfunction (flame failure, reduced air flow, bad combustion, etc.)
the heater stops and the power indicator starts flashing.
Shut Down
1)
Move switch to the
“
OFF
”
position.
-
Note:
Never disconnect the heater from the mains to stop it whilst it is in operation.
The heater outlet is very hot whilst in operation and after use
–
do not touch. Use
personal protection equipment if needed. Unplug the heater before moving it. Never
pull the cable to unplug or move the unit.
