5
3.
SAFETY REQUIREMENTS
Carefully read and follow safety requirements provided below before installing and while operating
the Unit:
Do not discard the Installation and operation manual, keep it for future reference.
The Unit should be installed and operated in compliance with this Installation and operation
manual, following the requirements of effective legislation and standards.
When connecting the Unit to mains supply, grounding must be installed in compliance with
requirements of effective legislation and standards.
To prevent accidents and potential damage to the Unit it should be installed, connected,
maintained and repaired only by qualified technician. Never attempt to do this by yourself!
Turn off the Unit by using Control panel and wait for fans to stop completely before replacing
air filters.
Turn off the Unit by using Control panel, wait for fans to stop completely and disconnect the
Unit from mains supply before performing any maintenance.
Disconnect the Unit from mains supply before disconnecting or reconnecting the control
panel.
Before connecting the Unit make sure that no items will get sucked into the its air intake
openings!
The Unit is not intended to be used by persons (including children) with reduced physical,
sensory or mental capabilities, unless they have been instructed to use the Unit and under
constant supervision of person held responsible for their safety.
Children may only use the Unit under adult supervision.
Only original supplementary parts and consumables, certified by manufacturer should be
used.
The Unit package (cardboard, plastic, foam polystyrene) can pose hazard to children. Dispose
or recycle the package elements!
Disused Unit should be disposed in accordance with requirements of legislation on handling
of waste electrical and electronic equipment.
IT IS PROHIBITED
to operate the Unit with damaged mains supply cable! Switch off the power
circuit-breaker to disconnect mains supply and contact a qualified technician or manufacturer
service centre immediately upon noticing such damage.
IT IS PROHIBITED
to attempt the repair of the damaged Unit or its part, to open its
maintenance and service hatch! Contact a qualified technician or manufacturer service centre.
IT IS PROHIBITED
to operate the Unit while construction works are still in progress to remove
dust or excess moisture. Fine dust of building materials, used in construction, can irreversibly
change characteristics of the heat exchanger or cause damage to sensitive electronic
components. Failure of the Unit caused by such operation will void the warranty.
