Initialisation and warming up
In a vehicle where single antenna
initialisation is used, drive forward
until system initialises.
AUTO
RD
STEP 5
Open windows explorer.
RD fi les can be accessed via
FTP either using an FTP client
or the windows explorer fi le
management tool.
While the I is operating, it
saves all data internally to a fi le
with suffi x .RD.
Static initialisation will take
approximately 30 sec-10 mins
depending on dual antenna
separation and measurement
accuracy.
Downloading and viewing data
30 sec-10 min
Land vehicles should drive in fi gures of eight with some acceleration
and braking and with the addition. After 15-20 mins system will be ready
for use. Monitor accuracy values in NAVdisplay’s ‘‘warm-up’’ template.
Once warmed up, system should
be left on. Data can be viewed
and recorded in NAVdisplay.
The fi les on the xNAV will then
be listed and the RD fi les can be
copied to your PC for processing.
In the address bar, type
“ftp://195.0.0.nn” where nn are
the last two digits of the serial
number.
STEP 4
LEAVE ON
Complete.
Support:
For further information,
please check the I
manual.
If you encounter any
issues during installation,
please contact our OxTS
support team via the
website.
Note:
The Kalman Filter
must warm up every
time the system is
turned on, so a short
warm-up is essential.
1
2
3
4
5
6
7
8
Web: www.oxts.com
Email: [email protected]
Phone: +44 (0)1869 238 015
I Quick Start Guide
