Oxgard Praktika K-01, Operational Manual

Page: 10 / 19

Praktika K-01 card collector 10
7. Operation of card collector
7.1. Startup
Connect the power supply unit to network 220V and turn it on. Card
collector will beep and red cross will turn on LED panel (Fig. 1). Card
collector is ready for operation.
7.2. Working modes
Standby mode
The mode is set after power-up. In this mode, the card collector waits
for a signal from ACS controller. Red cross is turned on on the display.
The mode of minimal power consumption.
Passage with permanent cards
When an authorized permanent visitor card is presented to the reader
card collector unlocks the speedgate for the time specified by ACS
controller (depending on the operating mode; for 5 seconds in pulse
mode). During the specified time interval other cards are not accepted.
When the passage is performed or the specified time interval is expired
card collector switches into standby mode and can collect the next card.
Green arrow turns on on the LED panel, indicating the authorization of the
passage.