Oxford Elevate, User Instruction Manua

Page: 21 / 116

Oxford
®
Elevate
1
English
294000.10065 Rev. A
1. BooM: Check the attachment of the boom to the mast. Make sure
ü ü ü
there is only minimal side movement of the boom and the boom
is free to rotate on the boom bearing.
. MasT: Check the operation of the mast-locking device. Make sure
ü ü ü
the mast fully engages into the socket. Check the bottom actuator.
. aCTuaTor: The actuator should require no
ü
maintenance other than checking for correct operation and
listening for unusual noise.
. poWEr paCK: Check the function of the
ü ü ü
emergency stop button and emergency lower.
. BaTTEriEs:
The batteries are housed in the power
ü
pack and should not require maintenance other than the regular
charging as detailed in the charging instructions. Check that the
connections remain clean.
. LEg aDJusTMENT: Check the legs operate in both full
ü ü ü
extensions (inward/outward).
. CasTors: Check all castors for firm attachment to the legs.
ü ü ü
Check for free rotation of the castor and the wheels.
. CLEaNiNg: Clean with ordinary soap and water and/or any hard
ü ü
surface disinfectant. Harsh chemical cleaners or abrasives should
be avoided as these may damage the surface finish of the lift.
Avoid wetting any of the electrical parts.
. LoaD TEsT: The load test should be carried out in accordance
ü
with the manufacturer’s test procedures. It is strongly recommended
the testing is carried out by an authorised service dealer.
10. BasE aND WHEELs: Ensure base is even and level
ü ü
ü
(all four wheels are on the floor).
11. sLiNgs: Check for wear and fraying.
ü ü
1. LuBriCaTioN: Lubricate pivot joints, including mast and boom
ü
connections, pedal assembly, spreader bar joint (only if required).
(you can use silicone grease/spray).
1. HaND sET: Ensure plugged fully into controller.
ü ü ü
*THEsE CHECKs sHouLD iNCLuDE:
Be
fo
re
u
se
initially service intervals