Handbook
November 2011
/
59-UMC0071
/
Issue
01
Mercury
iTC
Page 90
BASIC OPERATING INSTRUCTIONS
Original Instructions
7
To remove the X axis scale, tap once on the bottom of the X axis (see
Figure 6-2
Signal Monitor Plot page with Y axis scale only
6.4.2
To remove a trace from the plot
1
Tap
Plot
on the Home page. The Plot page is displayed.
2
Double-tap anywhere on the page. The Plot Configuration page is displayed.
3
Tap
Device
and select the required device.
4
Tap
Signal
and select the trace that is to be removed from the plot.
5
Tap
Delete
. The selected trace is removed from the plot.
6.4.3
To exit the plot
1
Double-tap anywhere on the page. The Plot Configuration page is displayed.
2
Tap
Home
to return to the Home page.
6.5
Configuring external interfaces
Only one external interface can be used at a time. refer to the relevant section for
information on configuring an external interface.
6.5.1
Configuring the ethernet interface (if required)
1
Obtain the required ethernet settings from the network administrator.
2
Tap
Settings
on the Home page.
3
Scroll to the
Ethernet
tab.
4
Tap
DHCP
and select either
On
or
Off
.
5
If
DHCP
is set
On
, the unit obtains its ipaddress from the network. No further
configuration is required.
6
If
DHCP
is set
Off
, enter an
IP Address
for the unit.
7
If
DHCP
is set
Off
, enter a
Subnet Mask
for the unit.
8
If
DHCP
is set
Off
, enter a
Gateway
value for the unit.
