version 1.1 rev 04 Mar 2020
18
Sona &
Marana
SECTION 3:
INSTALLATION
WARNINGS:
• PRIOR TO COMMENCING INSTALLATION, THE USER SHOULD REFER TO THE SAFETY AND WARNING
INFORMATION AND UNPACKING INSTRUCTIONS AT THE BEGINNING OF THIS MANUAL.
• DUE CARE MUST BE TAKEN WHEN LIFTING THE CAMERA. ENSURE THAT THE MOUNTING AND
CONNECTED ASSEMBLY IS SECURE AND ABLE TO SUPPORT THE WEIGHT OF THE CAMERA.
• POWER CABLING AND CONTROL CABLES SHOULD BE ROUTED TO PREVENT ACCIDENTS, DAMAGE AND
ACCIDENTAL UNPLUGGING WHILE AVOIDING BEND RADII OF LESS THAN 30 MM.
• TEMPERATURE AND HUMIDITY MUST MEET THE SPECIFICATIONS DEFINED IN TECHNICAL
SPECIFICATIONS.
3.1 t
RanspoRt
and
s
toRage
i
nfoRMation
• The camera is packed in a normal transport packaging for shipping.
• Allow the product to reach the ambient temperature after unpacking- especially if moving from a colder environment
to a warm environment as this may lead to condensation (see Section 6.1 for further information).
Storage
• Storage Temperature: -10°C to 50°C.
• If it is to be stored after use at a temperature below the coolant freezing point, ensure that all liquid coolant has been
expelled from the camera.
3.2 U
sing
tHe
l
ens
MoUnt
A C-mount lens mounting system is present on the 4.2B-6 models.
3.2.1 c-M
oUnt
R
eplaceMent
Note: C-Mount - Uses the inner set of mounting points
Removing the C-mount
1. Place the camera on its side (to prevent debris and dust landing on the window).
2. Use a 2mm hex key/driver to loosen the 4xM3 CSK (countersunk) screws.
3. Remove the 4 screws and carefully remove the C-mount from the faceplate.
Note: The use of nitrile gloves is recommended, when removing the C-Mount due to the proximity of the window.
Fitting the C-mount
1. Ensure that the faceplate is clean and free from debris.
2. Ensure that the O-ring is fully seated in the groove.
3. Locate the C-Mount part into the faceplate aligning the 4xM3 CSK screw holes.
4. Using the M3 CSK screws provided, tighten the mount to 1.1 Nm onto the faceplate.
Mounting
points (x4)
