The Oxford Garden Designs Round 48” Dining Table has
seven component parts - table top, (4) legs, and (2)
crossing foot braces.
To assemble:
1. On a clean surface, lay tabletop (G) on its back.
2. Install each leg (H) by placing two bolts through each
corner brace at each outside corner. Slide washer
(A) over each bolt and secure with nut (B).
3. Position crossing foot braces onto legs as shown in
drawing. Brace (I) will be secured first. Brace (I) is
the brace WITHOUT the four predrilled holes
surrounding the umbrella hole. Place insert nut (D)
into hole of one leg (H).
Hint: screw a bolt (C) into end of the insert nut (D),
place into leg hole & then rotate until hole in insert nut
points directly to end of leg to accept another bolt (C).
[see figure 1]
Tighten bolt (C) with allen key (E), and repeat for
remaining legs (H).
4. Drive the 4 woodscrews (F) through the predrilled
holes in cross brace (J).
5. Carefully turn table upright and enjoy.
RD48TA - Round 48” Dinning Table
RD48TA - Round 48” Dinning Table
RD48TA - Round 48” Dinning Table
RD48TA - Round 48” Dinning Table
RD48TA - Round 48” Dinning Table
