15 Kingbrook Parkway, Suite 100
Simpsonville, KY 40067
p. 877.866.3331 f. 502.719.8888
oxfordgarden.com
FRANKLIN ROCKER - FRCHK
ASSEMBLY
INSTRUCTIONS
Ver. 2019.06.03
COMPONENTS
HARDWARE
1
3
Right Arm Assembly
Quantity: 1
Right Rocker
Quantity: 1
2
Left Arm Assembly
Quantity: 1
B
4
Left Rocker
Quantity: 1
Dowels
Quantity: 28
A
Wood Glue
Brush
Quantity: 1
D
Wood Screws
Quantity: 4
B
e u l G d
o o W
Wood Glue
Quantity: 1
C
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: If the furniture is going to be placed on a concrete or
tile patio, it should first be rinsed well to remove the sawdust
that may cause some staining.
GLUING INSTRUCTIONS:
Correct assembly of this chair requires glue to be applied to
the final assembly joints using the supplied glue. To properly
glue these joints follow the directions below:
a. Lay the assembly part flat and apply a liberal amount of
glue into the mortise using the brush and glue supplied. Use
the brush to make sure the glue is thick on the inside walls of
the mortise.
b. Apply a liberal amount of glue to the complete tenon
using the brush to make sure the glue has contact with the
entire tenon.
c. Assemble the parts as instructed in the instruction steps.
After assembling the glued parts, use a damp cloth or
sponge to clean up any excess glue from the outer surface
of the furniture.
NOTE: A hammer (not provided) will be needed for the
assembly of this bar chair.
5
Seat
Quantity: 1
7
Front Seat Rail
Quantity: 1
6
Back
Quantity: 1
8
Back Seat Rail
Quantity: 1
