WWW.OXAUSA.COM
2. Preparation (refer to Figure 1)
The Notebook Mobile Power product must be fully charged before use. To charge the product, connect the enclosed AC
Adapter to the product (AC Adapter Input) and to an appropriate AC power source. The unit will take approximately (6)
hours to reach full charge. The LED in the Power Switch will illuminate RED to indicate that the unit is charging and will
turn BLUE when the unit is fully charged.
Lightly press the Power Switch to display the Battery Capacity Status (
refer to Table 1
).
Battery Capacity Status LED
Charge Capacity
(5) LEDs Illuminated
75% - 100%
(4) LEDs Illuminated
50% - 75%
(3) LEDs Illuminated
25% - 50%
(2) LEDs Illuminated
5% - 25%
(1) LEDs Illuminated
Less than 5% power remaining
Table 1
3. Operation (refer to Figure 1)
1) To connect to the 5V USB output port, follow these steps:
a. Select the appropriate phone connector for your device and insert it onto the end of the enclosed USB
power cable and then plug this end into your mobile device.
b. Plug the USB end of the cable into the Notebook Power Station.
c. Note: You can also use the USB power cable that came with your device if you prefer.
d. Note: the USB 5V output can be used simultaneously with the 19V output.
2) To connect to the 19V output port, follow these steps:
a. Select the Laptop Connector that corresponds to your Laptop DC Input voltage port and insert it onto the
end of the enclosed power cable and then plug this end into your laptop DC input voltage port.
b. Insert the other end of the cable into the 19V output port on the Notebook Power Station.
c. Note: the 19V output can be used simultaneously with the USB 5V output.
