3
INTRODUCTION
PRECAUTIONS
Safety
- Exercise caution when working with any optical equipment. High-intensity fiber optic laser sources output potentially
dangerous high energy invisible light, and could cause serious, irreparable damage to the eye. Thus, it is recommended to
look into the connector port of a light source or the end of a fiber.
Operational
- It is important to keep connector ferrules and optical connector ports clean. If dirt, dust, and oil are allowed to build up
inside connector ports, irreparable damage may occur to the optics inside the port. For best results, replace dust caps after each use.
Connector
- if you have the optional Visual Fault Locator installed, do NOT insert APC (Angled Physical Contact) connectors into the
VFL port on your ZOOM 2 as this may damage the angled ferrule on the APC connector.
NEVER
On the back of each ZOOM 2 series optical power meter is a label similar to the one shown below containing model number, serial
number, power requirements, and special cautionary information. If the unit is enclosed in its protective boot, the boot must be
removed to view this label.
PRODUCT LABEL
MADE IN USA
BATTERY CHARGER WARNING
MODEL# ZO-2V
SERIAL# ZV13019
POWER: 9V DC
DO NOT USE THE BATTERY CHARGER
W H E N T H E R E I S A N O N -
RECHARGEABLE BATTERY IN THE
BATTERY COMPARTMENT.
Conforms to the Harmonized
European Standards EN
61326-1 and EN 61010-1.
MADE IN USA
BATTERY CHARGER WARNING
MODEL# ZO-2
SERIAL# ZO13019
POWER: 9V DC
DO NOT USE THE BATTERY CHARGER
W H E N T H E R E I S A N O N -
RECHARGEABLE BATTERY IN THE
BATTERY COMPARTMENT.
Conforms to the Harmonized
European Standards EN
61326-1 and EN 61010-1.
