3
PRECAUTIONS
Eye Safety
look into the connector port of any fiber optic test or transmission equipment, patch cable, fiber link, or other
installed fiber. Always assume that active laser equipment is attached to optical fibers, and is powered on.
Do not run a test on the OTDR unless it is connected to the fiber under test, or the dustcap is firmly in place.
Electrical Safety
Only use appropriate AC adapters for charging this device. Use of inappropriate power adapters could cause damage to
the device, and could cause harm to the user from fire and electrical shock.
Operational
eep connector ferrules and optical connector ports clean to prevent irreparable damage to the OTDR port. For best
results, replace dust caps after each use.
Connector
do NOT insert APC (Angled Physical Contact) connectors into the OTDR port.
Service
NEVER
K
For best results,
There are no user-serviceable parts in this device. Unauthorized attempts to service this product will void the product
warranty.
PRODUCT LABEL
SECTION 1: INTRODUCTION
On the back of each OWLTrek OTDR is a label similar to the one shown here containing model
number, serial number, power requirements, and special cautionary information.
WARNING
ASSEMBLED IN USA
Optical Wavelength Laboratories
Whitewater, WI 53190 • 262-473-0643
MODEL#: WTO-S15
SERIAL#: RT99999
Class 1M Laser Product
IEC 60825
Output Type: FP Laser
Output
8
: 1550nm
Regulated, Center positive
Power: 6VDC, 1 A
