STEP 5
Compare the reading on the Fiber OWL 4 BOLT display to Table 1 for acceptable power levels.
STEP 6
Once proper operation has been verified, remove the first patch cable from both units and set it aside.
STEP 7
Connect the second patch cable between the Fiber OWL 4 BOLT and the WaveSource, as shown in
Figure 3.
STEP 8
Compare the reading on the Fiber OWL 4 BOLT display to Table 1 for acceptable power levels.
STEP 9
Once proper operation has been verified, remove the second patch cable from both units and set it
aside.
STEP 10
Connect a mandrel wrapped patch cable between the Fiber OWL 4 BOLT and the WaveSource as
shown in Figure 4.
STEP 11
Compare the reading on the Fiber OWL 4 BOLT display to Table 1 for acceptable power levels.
STEP 12
Disconnect this cable from both units, and set it aside. Press
<DONE>
to return to the OPERATING
MODE menu.
RUN LINK WIZARD
STEP 13
From the OPERATING MODE menu, select CERTIFICATION METER.
STEP 14
From the START MENU, press
<1>LINK WIZARD
.
STEP 15
From the STORED LINKS menu, highlight the stored link name you wish to use and
press
<F2>
to select.
Core Size
62.5/125 µM
50/125 µM
Replace at
-22.00 dBm
-25.00 dBm
Acceptable Power Level
-19.0 to -22.0 dBm
-22.0 to -25.0 dBm
TABLE 1
FIGURE 4
Connection for
Mandrel-Wrapped
Patch Cables
<1>LINK WIZARD
<2>TAKE READINGS
<3>MAIN MENU
START MENU
Fiber Link #2
NEXT
SELECT
Fiber Link #3
Fiber Link #4
STORED LINKS
_____________________
Fiber Link #1
LIGHT SOURCE CONNECTOR
PORT NOTES:
– CONNECTOR TYPE MAY VARY
– DO NOT INSERT ANGLED
PHYSICAL CONTACT (APC)
CONNECTOR