3 LED Indicators
3
LED Indicators
GE-2032R comes with six LED indicators on the backplane of the adapter. LED indicators
inform you about the network status as shown in the Fig. 3-1.
If you experience any problem with the adapter, first check the followings:
the appropriate driver is loaded
the proper cable is connected to the RJ-45 port of the adapter
the switch should complies with the 10/100/1000BASE-TX specifications.
You should make sure that all the above requirements are met, then check the LEDs again to
make sure the connection is valid and working.
LED indicators of GE-2032R
The NIC supports full duplex at 10/100/1000BASE-TX. If the switch supports NWay feature
and full duplex, the GE-2032R NIC automatically runs in full duplex.
If there is a problem with the connection, first check the network cable for possible breach. If
that does not resolve the problem, try to replace the cable.
FDUP
100M/ACT
1000M/ACT
10M/ACT
Fig. 3-1 LED indicators of GE-2032R
10M/ACT:
Light up to indicate a 10Mbps connection has been established.
Flashing indicates transmission activities.
100M/ACT:
Light up to indicate a 100Mbps connection has been established.
Flashing indicates transmission activities.
1000M/ACT:
Light up to indicate a 1000Mbps connection has been established.
Flashing indicates transmission activities.
FDUP:
Light up to indicate the port is operating in Full Duplex Mode. Off
means it is operating in Half Duplex mode. Flashing to indicate collisions.
For details information on LED color and status, please view the LED Table on the
next page.
- 10 –
OvisLink GE-2032R User’s Guide
