Musto Skiff – Rigging Guide (v0.5) -Jan 2019
15 of 19
Fitting the Rudder
63. Offer the stock up to the pintles and insert the pin from
below the bottom pintle plate
64. Insert the split ring at the top to hold the pin in place.
Once on the stock it can be left on the boat permanently.
65. Clip the tiller extension onto the tiller.
66. Insert the rudder blade. Friction will keep it up.
Fit the Bung and Tape EVERYTHING up
NOTE: The following rigging fittings that are designed to be adjustable may be adjusted when not racing using only the fitting
functionality – (i) the angle and length of the mast spreaders, (ii) inboard, outboard and forestay shroud adjusters, and (iii) the
batten tensioners.”
67. Don’t forget to put the bung in!!!!
68. Tape everything up -, “if in doubt, tape it up”
