18
5.
CB/PA Switch
. Selects mode of operation. In the CB position, the PA function is
disabled and the unit will transmit and receive on the selected channel, The PA
function should not be used unless a PA speaker is connected.
6
. S-RF/Power Meter.
Shows relative transmitter RF output power and input signal
strength when receiving. The five LED (Light Emitting Diode) segments glow to
indicate receive or transmit activity.
7.
TX Indicator.
This indicator will light red when in the transmit mode.
8.
Channel Display.
The selected operating channel will be displayed here.
9.
Channel Selector Switch.
When turned, this knob is used to select any one of the
forty citizens band channels desired.
For a
“
RAPID” change of channels, depress and hold the desired button (up and
down). This allows all 40 channels to be covered in about 6 seconds.
Other operation Features
•
Automatic Noise Limiter.
This is a non-switchable feature that is always on to
reduce background noise.
C. Rear Panel
1.
ANTENNA CONNECTOR:
This SO-239 connector permits connection of the
transmission line cable male connector to the transceiver.
2.
PUBLIC ADDRESS:
An external 8-ohm 4.0 watt PA speaker may be connected to the
PA Speaker Jack when this unit is used as a public address system. The speaker should
be directed away from the microphone to prevent acoustic feed-back. Physical separation
or isolation of the microphone and speaker must be employed when operating the PA at
