NEO Spare Base Module Instructions
10400858-001
©2018 Overland Storage, Inc.
Page 2 of 7
Remove Tape Magazines
Make sure all activities are completed and all backup software
services are stopped. Remove the tape magazines from the
Base Module being replaced.
NOTE:
If a magazine needs to be removed when the power to the
device is off, refer to the
below.
1.
From the OCP or RMI, first select the right magazine and
then select
Open Magazine
.
2.
Using the right magazine
access handle
and supporting
it underneath, pull the magazine out of the library.
3.
Place the magazine on a secure surface.
4.
Repeat
for the left magazine.
Manual Release Process
If power is not available on the Base Module, the magazines
can be released using the manual release hole on the side of the
magazine. Insert a small flat head screwdriver or Torx driver
into the appropriate magazine release hole and gently push the
tab in.
IMPORTANT: Do not continue to exert force once you
encounter resistance. Doing so can damage the device.
Power Off Library
If still running, power off the library from the Base Module
front panel by pressing and holding down the power button for
three (3) seconds.
NOTE: If the library does not perform a soft shutdown, press and
hold the power button for 10 seconds.
Verify that the Robotic Assembly is in its parked position and
that all host processes are idle.
Remove Old Base Module
Remove Cords and Cables
Disconnect all cables and cords, noting where they connect.
1.
Unplug any
AC power cords
(1).
2.
Remove the
expansion interconnect cables
(2) from
the Base Module and any Expansion Modules to which it
is connected.
NOTE: Completely removing the cables from both ends
prevents damaging the expansion interconnect cables during
module removal and replacement.
3.
Label and remove any Ethernet
management cables
(3).
4.
Label and remove any
SAS/FC cables
(4) from the tape
drives.
5.
If present, remove the optional
USB device
(5).
Manual Release Holes
1
3
4
5
2
2
