10400898
©2019 Overland-Tandberg
Page 1 of 5
Quick Start Guide
NEOxl 80 6U Expansion Module
This document describes how to add an optional Expansion
Module to a NEOxl 80 6U tape library system.
Step 1
It is
essential
that you activate your warranty. Technical
and warranty support are
not available
until the warranty
is active.
The serial number is located at the rear of the module on the
bottom left cover.
Module Registration
For an
existing customer
:
1.
http://support.overlandstorage.com/
support page.
2.
Enter your
address
and
password
in the appropriate fields,
and then press
Enter
or
click the right arrow (
>
).
3.
At the Support Home page, click
Register New
.
4.
Enter the requested information and click
Submit
.
Your warranty certificate will be emailed to you. Follow
the instructions in the email to complete the process.
For a
new customer
:
1.
Go to the
page and follow the
instructions.
2.
You’ll receive a confirmation e-mail from Overland with
instructions on how to complete the process.
*10400898*
10400898
Step 2
WARNING: Due to the weight of the module, it is
recommended that at least two people be used to lift the
module out of the box to prevent injury.
WARNUNG: Um Verletzungen zu vermeiden, empfehlen
wir aufgrund des Gewichts des Moduls, dass mindestens
zwei Personen das Modul aus der Verpackung heben.
AVERTISSEMENT: En raison du poids du module, il est
recommande d'utiliser deux personnes au moins pour
soulever l'module hors de la boîte pour éviter les
blessures.
NOTE: If the temperature in the room where the module will be
installed varies by 15º C (30º F) from the room where the boxed
module was stored, allow it to acclimate to the surrounding
environment for at least 12 hours before unpacking it.
Unpack the Module
1.
Using two people, remove the
module
from its box and
set it on a secure surface.
2.
Remove and save the
packaging materials and tape
from the Expansion Module.
Tools Needed
You will need a small flat head or Torx screwdriver and a #2
Phillips screwdriver.
Step 3
Power Off Library
If still running, power off the tape library from the Base
Module front panel by pressing and holding down the power
button for three (3) seconds.
NOTE: If the library does not perform a soft shutdown, press
and hold the power button for 10 seconds.
Verify that the Robotic Assembly is in its parked position
and that all host processes are idle.
