10400287-002 03/2011
©2010-11 Overland Storage, Inc.
Page 3 of 7
Quick Start Guide
2.
Repeat
for the
right
slide rail assembly.
3.
Verify that the
rails
are level and straight.
Continue with
“Install the Unit in the Rack.”
Round-Holed Rack Installation
Before installing the rails onto an unthreaded round-holed rack,
the round-hole rail kit adaptors must be installed on the ends of
the outer rails.
1.
Attach the
adaptors
to both ends of the rail:
a.
Position the adaptor stamped “A” at the front of the
left
outer rail
(end with the graphic label).
NOTE: Make sure the stamp is at the top and the square adaptor
holes are aligned with the hooks on the outer rail.
b.
Press the
adaptor
onto the hooks and slide it
upwards
until it locks (clicks).
NOTE: The rail buttons will snap into the square holes.
c.
Repeat
for the
left rear
adaptor (stamped “B”).
2.
Facing the rack, position the
left rail
in the rack, aligning
the adaptor holes with the
front
left rack holes being used.
3.
Using the
screws
from the kit, secure the
front
of the rail to
the rack.
4.
Slide the
rear rail segment
rearward until the
rear
adaptor holes are in line with holes being used.
5.
Using the
screws
from the kit, secure the
rear
of the rail to
the rack.
6.
Repeat
for the
right rail
.
7.
Verify that the
rails
are level and straight.
Continue the installation with
“Install the Unit in the Rack.”
Install the Unit in the Rack
WARNING: It is recommended that a mechanical lifter (or at
least two people) be used during rack installation or removal to
prevent injury.
AVERTISSEMENT: pour éviter toute blessure il est recommande
qu'un monte-charge (ou deux personnes au moins) soit utilisé
lors de l'installation ou de l'enlèvement du support.
1.
At the front, extend the
middle
rail members until they lock
(click).
2.
Confirm that the ball-bearing
shuttles
are at the
front
.
3.
Using a mechanical lifter or two people, insert the server into
the rack
rails
.
Lift the server to its install height and engage the
inner
members
on the server with the middle members
protruding from the rack, and slide the server into the rack
until it stops.
A
B
(Front)
(Rear)
Adaptor
“A” Stamp
Bearing Shuttle
