10400244-002 Jul 2013
©2009,2013 Overland Storage, Inc.
Page 3 of 4
2.
Locate the
quick-release plate screws
on the back
side of the card.
3.
Remove and retain the
two screws
, and slide the
quick-release plate off the
new
card.
4.
Using the retained screws, attach the
quick-release
plate
to the
old
card.
5.
Package the
old card
in the ESD bag for return.
Install the New Card
1.
Carefully insert the
new controller card
observing
ESD procedures. Ensure the plastic sleeve around the
toggle switch stays on.
2.
Slide the rear of
card cage side plate
over the toggle
switch and insert it onto the three side tabs.
3.
Gently twist the
tab edges
to secure the plate.
4.
Reinstall the
side panel
:
a.
With the rear angled out slightly from the library,
fasten the
front hook
onto the front panel.
b.
Swing the
rear
toward the unit until all the tabs are
aligned with their respective holes.
c.
Using
two
new M3x6mm screws, secure the
card
cage top edge
to the side panel.
d.
Using
14
new M3x6mm screws, secure the
side
panel
to the library.
5.
Using
five
new M4x6mm hexhead screws, reattach the
inner side rail
.
6.
Replace the
front top
cover
:
a.
Slide the
cover tabs
into their slots and gently set
the front top cover into place.
b.
Insert the
two retained screws
and tighten them.
Reinstall the Library
1.
Using a mechanical lifter (or two people), reinstall the
library
into the rack.
2.
If removed, reinstall each of the
drive assemblies
:
a.
While fully supporting the
assembly
, line it up with
the open bay and slowly push it into the bay until it
seats firmly against the backplane.
b.
Tighten the two captive
thumbscrews
.
3.
Reconnect all
external cables
.
4.
For SCSI systems, verify the
terminators
are still
attached to the drive housings.
5.
If used, reconnect the
XpressChannel
and, for a
Master unit, plug in the
DB-15 cable
.
6.
Manually open the doors and reinstall the
magazines
.
Continue with
“Complete the Installation” on page 4
CAUTION:
The Library Controller card only functions in
the right-most slot of the Primary card cage.
1.
Using a Phillips screwdriver, loosen the
retaining
screws
at the top and bottom of the card.
2.
Push the
top ejector handle up
and the
bottom
ejector handle down
to release the card.
3.
Slide the
card
out of the bay.
4.
Carefully insert the
new card
into the right-most slot
and slide the card into the bay.
Resistance will be felt when the card begins to mate
with the library backplane.
5.
Using the card handles, apply just enough force to
seat
the card
snugly
into the library backplane.
6.
Tighten the hold-down
screws
on the card.
“Complete the Installation” on page 4
.
Remove These Screws
Squeeze These Points Together
Replacing the NEO 4000e Card