5
Version 1.4 - Subject to change without notice
FRONT PANEL
On the front cover of the device there are 16 LEDs placed along its
circumference, distributed, as shown in the figure, in the area highlighted
in blue. The LEDs light up in different ways to communicate the different
states of the device. Below is the list of possible types of lighting and their
associated meanings.
Quick flashing
: As soon as it is connected to the power supply, the
LEDs will flash rapidly to confirm correct power supply.
Continuous power on
: The LEDs will light up once at a time,gradually
and in a clockwise rotation indicating that the device is not calibrated.
When this happens, please contact support.
Rotation
: The LED strip lights up in a clockwise circular movement to
indicate that the device has entered the programming mode.
Double flash
: This indicates that the device has been pressed.
1
2
3
4
WARRANTY
This product is guaranteed against any material and manufacturing defects according to the period established by law from the date of purchase, even if
the product has not been installed. The warranty period starts from the moment of purchase. The buyer must report any defects in the delivered products
in writing to OVER
S.p.A.: the communication must contain a description of the reasons for defects and/or discrepancies, also indicating the serial
number, the delivery date, the delivery number, and date of the transport document or invoice.
The supplier’s warranty does not extend to products that are defective and/or damaged due to natural attrition or breakdown caused by improper use
or an operating procedure not contemplated in this manual, of negligence, or are tampered with or repaired by third parties or accidentally damaged
caused by atmospheric agents, or firmware updates.
The warranty intervention by the supplier remains subject to the buyer’s compliance with the payment conditions as well as the technical evaluation of
the existence of the warranty conditions verified by O
VER S.p.A. During the warranty period, OVER S.p.A. undertakes to repair or replace, free of charge,
those products that have manufacturing defects or bad quality at its headquarters.
RETURN AND REPAIR PROCEDURE
All returned products must meet the same condition in which they were supplied at the buyer’s expense, to the headquarters of OVER S.p.A. in Viale
Piemonte 37 - 20093 Cologno Monzese (MI) and packed by the buyer in order to avoid damages for which the buyer would be responsible.
No return goods will be accepted in the absence of authorization by OVER S.p.A. to the buyer.
No refund, even if authorized, will be accepted if the information regarding quantity, type of device returned and reason for return is not included in the
transport document or the accompanying letter.
Products not covered by the warranty will be returned to the buyer at their own expense and charged the costs incurred, after quantification and
communication, for the control and further testing and calibration of the same.
The replaced parts remain the property of OVER S.p.A.
DECLARATION OF CONFORMITY
OVER
S.p.A. declares that its family of instruments complies with the directives EMC 89/336/ECC 73/23CE 93/68 CE and meets the requirements of the
following product standards IEC 61326, IEC 61010.
The device was tested in the typical installation configuration and with peripherals complying with the directive EMC and the low voltage directive.
Device designed, produced, and distributed by OVER S.p.A.
This manual was last updated on 04/27/2021.
The latest updated version of the manual is available in digital format downloadable from the website www.overtechnologies.com
Check that the version of this manual, written on the front cover, corresponds to the updated version of the manual.
ASSISTANCE
www.overtechnologies.com
