4
Version: 1.1
EXAMPLE OF CONNECTION
BASIC INSTRUCTIONS
•
You can control the power outputs by assigning
them to designated inputs programmed by the
software embedded in the OBox device.
•
When the OMeter starts, the relays are closed.
However, the outputs can be programmed so that
they revert to their last state when restarted. Note
that in any case, when the control unit is restarted,
all the relays remain temporarily closed (for about
3 seconds). When the OMeter is not powered, the
relays will remain closed.
WARRANTY
This product is guaranteed against any material and manufacturing defects according to the period established by law from the date of purchase, even if
the product has not been installed. The warranty period starts from the moment of purchase. The buyer must report any defects in the delivered products
in writing to Over S.p.A.: the communication must contain a description of the reasons for defects and/or discrepancies, also indicating the serial
number, the delivery date, the delivery number and date of the transport document or invoice.
The Supplier’s warranty does not extend to products that are defective and/or damaged due to natural attrition or breakdown caused by improper use
or an operating procedure not contemplated in this manual, of negligence, or are tampered with or repaired by third parties or accidentally damaged
caused by atmospheric agents, or firmware updates.
The warranty intervention by the Supplier remains subject to the Buyer’s compliance with the payment conditions as well as the technical evaluation of
the existence of the warranty conditions verified by Over S.p.A. During the warranty period, Over S.p.A. undertakes to repair or replace, free of charge,
those products that have manufacturing defects or bad quality at its headquarters.
RETURN AND REPAIR PROCEDURE
All returned products must be returned in the same condition in which they were supplied at the Buyer’s expense, to the headquarters of Over S.p.A. in
Viale Piemonte 37 - 20093 Cologno Monzese (MI) and packed by the Buyer in order to avoid damages for which the Buyer himself would be responsible.
No return of goods will be accepted in the absence of authorization by Over S.p.A. to the Buyer.
No refund, even if authorized, will be accepted if the information regarding quantity, type of device returned and reason for return is not included in the
transport document or the accompanying letter.
Products not covered by the warranty will be returned to the Buyer at his own expense and charged to him for the costs incurred, after quantification and
communication, for the control and further testing and calibration of the same.
The replaced parts remain the property of Over S.p.A.
DECLARATION OF CONFORMITY
Over S.p.A. declares that its family of instruments complies with the directives EMC 89/336/ECC 73/23CE 93/68 CE and meets the requirements of the
following product standards IEC 61326, IEC 61010.
The device was tested in the typical installation configuration and with peripherals complying with the directive EMC and the low voltage directive.
Device designed, produced and distributed by Over S.p.A.
This manual was last updated on 11/27/2020.
The latest updated version of the manual is available in digital format downloadable from the website www.overtechnologies.com
Check that the version of this manual, written on the front cover, corresponds to the updated version of the manual.
ASSISTANCE
OVER SPA
-
Via Maffio Maffii, 11 - 00157 Rome (Rm), Italy - TC/VAT N° 12065001005
