![background image](http://html1.mh-extra.com/html/oventrop/cs-bs-1-wlan/cs-bs-1-wlan_manual_1662704026.webp)
en
26
Installation
Configuration
W
eb interface
Eliminating er
rors
Displa
ys
Carry out the connection of the device
to the controller / other mod-
ules in the order described below:
Î
Connect the data cable (S-Bus,
) to an Oventrop controller
. If necessary,
extend the cable using a 2-wire cable (bell wire).
Î
Connect S-Bus accessory
via the data cable, if necessary.
If a further S-Bus cable is to be connected, proceed as follows:
Î
In order to open the housing, unscrew the screw and remove the upper part
of the housing.
Î
Connect the 2-wire cable (bell wire) to the 2 S-Bus terminals (A) and (B) with
any polarity.
Î
Close the housing.
(A) (B) (C) (D)
Connection terminals of the Datalog
Î
Connect the device to the mains by means of the mains adapter
.
Î
For a direct connection to a router, connect the device to a router
using the
network cable (included with the device,
). Or use the WLAN.
www
3.3
(W)LAN connection
The Datalog CS-BS-1 WLAN can be connected to a router by using a network
cable (CAT5e, RJ45 or similar) or via WLAN (see chap. 4.2 on page 27).
Î
Connect the network cable included to the LAN connector of the router and
to the LAN connector of the CS-BS-1 WLAN.
For the next step of commissioning, see chap. 5.2 on page 30.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.
Summary of Contents for CS-BS-1 WLAN
