7
V1.0
www.ovationlight.com
ing modes.
Addressing
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture
responds to the correct control signals. This digital starting address is the channel number from which
the fixture starts to listen to the digital control information sent out from the DMX controller. The alloca
-
tion of this starting address is achieved by setting the correct number on the display located on the base
of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address for
each fixture individually.
If you set the same address, all the units will start to listen to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures simulta
-
neously.
If you set a different address, each unit will start to listen to the channel number you have set, based on
the quantity of control channels of the unit. That means changing the settings of one channel will affect
only the selected fixture.
In the case of the Power Par 350 TW, which is 4 channels fixture. If you set, for example, the address in
the 4 channel mode to channel 5, the device will use the channel 5 to channel 8 for control.
Universal DMX Control
This function allows you to use a universal DMX-512 controller to control the dimmer and strobe. A DMX
controller allows you to create unique programs tailored to your individual needs.
Stand-alone mode
In this mode, the fixture can be operated without a controller.
1. Press the
MENU
button.
2. Press the
UP
or
DOWN
button to slect “
CC--”
, “
CP--”
, “
DE--”
which can be used as stand-alone
mode, and press
ENTER
.
3. Press the
UP
or
DOWN
button to adjust speed of the programs, speed increasing from 00-99.
Note:
Disconnect the fixture from the controller in stand-alone operation.
Master-Slave Operation
This function will allow you to link up to 16 units together and operate without a controller. In a Master-
Slave set up one unit will act as the controlling unit and the others will react to the controlling units pro-
grams. Any unit can act as a Master or as a Slave.
1.
Using approved DMX data cables, daisy chain your units together via the XLR connector on the rear
of the units.
2.
Set the desired Master mode. The following mode can act as master mode: “
CC--”
, “
CP--”
, “
DE--”,
“Oxxx“, “Yxxx“, “Txxx“.
3.
For the slave units. Set the DMX address to 001.
4.
The slave units will now follow the Master unit.
Sound active mode
In the sound mode, the fixture can run with the beat of sound.
1. Press the
MENU
button and select “
BEBE”
.
2. Press the
ENTER
button to confirm.
