OV1016 | 13
User Guide: OV1016
ASSEMBLY INSTRUCTIONS
ATTACH ALL CABLES TO THE TABLE FRAME
OR ON THE UNDERSIDE OF THE TABLE TOP
Attach cables in order to avoid any damage during operation.
Be sure to leave enough slack in the cables to allow for the
table to move into it’s highest position.
CONNECT SIDE-BY-SIDE TABLES
*
*For units specified to use a side-to-side connector, attach
lower tray to the bottom of the ganging bracket of each
bench using the M4-0.7x6mm length screws. The maximum
tightening torque for these screws is 4Nm (35in-lbs).
Once installed, the upper tray can be slid on to fit.
11
12
CONNECT THE SUPPLIED POWER CORD
(AC) TO THE CONTROL BOX
