Set printer to label size
Press CALIBRATE GAP/BLACK MARK SENSING if printer is adjusted to
the label size. Thereby the driver calibrates the sensor to the label and the
label carrier. After that the GAP-/BLACKMARK sensor is able to detect the
gap between labels
.
1
2
1
3
Measure the width of the label roll.
Set the sensor flag GAP-/BLACK MARK [2] into a position, at which the
gap between labels will be detected.
Note:
If labels are round or oval you must place the sensor lever into a position
where the gap between the labels is most minimum.
At Black Mark detection (black mark on label carrier
adjust the sensor to
the marks on the rolls.
Depending on the label type you must set SENSOR SETTING!
On the right side set paper feed [3] to the label width.
Caution:
To avoid e.g. paper jam slide the paper guides firmly against the edges of
the paper.
15
