Outland Technology UWS-3310, Operating Instructions Manual

Page: 1 / 31

OUTLAND TECHNOLOGY INC.
38190 Commercial Court
Slidell, Louisiana U.S.A. 70458
Ph.(985)847-1104, Fax 1106
Email: sales@outlandtech.com
Website: www.outlandtech.com
UWS-3310/3320
OPERATING INSTRUCTIONS
1. To operate Camera System, all interconnections from the Control
Unit,
D
VR & Monitor, should already be connected but in the
event there is a problem drawing # 0010550 shows how those
items connect.
CAUTION :
Insure voltage does not exceed 250 volts AC to
the Console. Also power source must be properly
grounded. Typically 110 VAC to 250 VAC.
2. Plug Camera Umbilical into Camera and light (Be sure to use a
good quality silicon grease for lubrication). Plug topside
end of umbilical into Control Unit connector on front panel.
3. After verifying supply power is correct, insure camera, light
switches are in off position. Plug into power source.
4. Turn Monitor, Recorder and Camera switches on. A picture should
appear within a few secs.
5. Insure "Light Intensity" is at "Min" position. Turn light
switch on. Turn control up to test light. Turn back to Min.
and Turn switch off.
CAUTION :
" Light can be operated out of water but will shut
down automatically if the temperature exceeds 50c.
6. The CON-3300 console only outputs 24 VDC maximum.