7
PACKING AWAY YOUR AWNING
Zip up all the windows and doors before deflating.
Unpeg the guy lines, storm straps and most of the pegs around the
awning - leaving the four corners pegged out.
Open each of the Dynamic Speed Valves in turn and press in the quick
release button. Leave the button pressed in.
Unpeg the four corners and pull the awning out of the awning channel.
Lay the awning flat on the ground and push as much air out of it as
possible.
Fold the awning lengthways
from the opposite ends to the
valves to push all the air out.
Make a long thin sausage shape.
Begin to roll the awning as tight
as possible towards the valves
to expel all the air as you roll.
Place the rolled awning on to
the bag and pull the sides up
round it. Finally, Zip up the bag.
Measure the width of the bag
up against the width of the fold-
ed awning to make sure the
awning is going to fit.
6
WARNING: Never unzip the zips on the protective
sleeves whilst the AirFrame Tubes are inflated. This will
result in the tube bursting or ballooning out of the
sleeve causing damage to the tube and the sleeve.
This is not covered under the warranty.
11. Peg out all the remaining pegging
points and guy lines starting from the
corner against the caravan and work
round the awning.
10. Place these Individual Air Spacers in to
the Velcro slots along the roofline to keep
the roof tight.
13. Finally thread the included draught
skirt through the draught skirt channel
and secure at either side.
12. Peg out the Reflective Endurance Storm
Straps for extra stability. Please make sure
in heavier weather you use all the guy lines
and storm straps to hold the awning in
place.
