Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. U • 3/12
5
A. Design and Installation Considerations
When planning an appliance installation, it is necessary to
determine the following information before installing:
• Where the appliance is to be installed:
- Clearance to side walls
- Location of adjacent stairwells
- Doors
- Windows
- Walkways
- Wires
- Possibility
of
fl ooding or running water
• Location of gas supply piping
• Electrical wiring requirements
• Framing
and
fi nishing details
2
2
Getting Started
The Carolina Series outdoor gas fi replace is designed for
outdoor use and may be installed as a standalone unit or
built into an outside wall.
It may be installed in screened porches and lanais that meet
these minimum requirements:
• Minimum porch area - 96 square feet
• Minimum ceiling height - 82 in.
• Minimum distance from top of appliance opening to ceiling
- 49.5 in.
A minimum of one wall can be screened but must be open to
outside ventilation. Minimum requirements are:
• Minimum screen area - 64 square feet
• Minimum screen top height - 80 in.
If this fi replace is to be installed within a wall, you must:
• Provide access to the gas controls.
• Slope
outdoor
fl oor (and hearth) away from fi replace.
• Flash the perimeter of the fi replace, corners and the
fireplace face in a manner consistent with regional
practices as required to prevent water penetration around
the fi replace or manage water that may penetrate the
fireplace. See Section 3.D. and Figure 3.1 for more
information regarding wall and enclosure construction.
The fi replace may be installed on a wood or noncombus-
tible deck.
Refer to Sections 3.D. and 3.E. for clearances.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
Reciprocating saw
Framing material
Pliers
Non-corrosive leak check solution
Hammer Gloves
Phillips screwdriver
Framing square
Level
Electric drill and bits (1/4 in.)
3/4 in. wrench
7/16 in. wrench
7/8 in. wrench
1/4 in. nut driver
Crescent wrench
Pipe sealant
Plumb line
Safety glasses
Manometer Voltmeter
Tape measure
Flat blade screwdriver
Caulking material (300ºF minimum continuous exposure
rating)
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
C. Inspect Appliance and Components
•
Carefully remove the appliance and components from the
packaging.
• Remove screen package from grate, set aside.
• The gas logs are packaged separately and located on
top of the fi rebox along with the lava rock. The installation
manual will be found inside the fi rebox.
• Report any parts damaged in shipment to your dealer.
• Read all of the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety and
benefi t.
WARNING! Risk of Fire or Explosion!
Damaged parts
could impair safe operation. DO NOT install damaged, in-
complete or substitute components. Keep appliance dry.
WARNING! Risk of Fire, Explosion or Electric Shock! DO
NOT use this appliance if any part has been under water.
Call a qualifi ed service technician to inspect the appliance
and to replace any part of the control system and/or gas
control which has been under water.
Hearth & Home Technologies disclaims any responsibility for, and
the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance or vent
system component.
• Modifi cation of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
Any such action may cause a fi re hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualifi ed
service technician, service agency or your dealer.
