LIGHTING
Always visually inspect your grill before lighting. Replace any hoses that are frayed or cracked before lighting
your grill. Look for anything that may be blocking spaces for ventilation and remove. After lighting, always
check the flame to ensure you have a good flame all along each burner. If not able to light, or the flame is not
even along the entire burner(s), then see the Trouble Shooting section
!
WARNING
1.
Read instructions before lighting.
2.
Open lid during lighting.
3.
If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes and repeat the
lighting procedure as below:
LIGHTING THE MAIN BURNERS USING ELECTRONIC IGNITION
1.
Open the lid.
2.
Ensure all burner control knobs are in the “Off” position.
3.
Turn on the LP gas by turning the hand wheel on the cylinder valve.
4.
Turn one burner control knob marked with an igniter flame “ ” to “High”.
5.
Depress the electronic ignition button and hold down. You should hear a
clicking sound, which shows the electronic ignition is working.
6.
If the burner does not light within 5 seconds, turn the burner control knob to “Off”. Wait 5 minutes for the
gas to clear, and repeat the above procedure. Use the Manual directions if it still will not light.
7.
When lit, turn the control knob to the desired setting.
8. Your grill is equipped with continuous ignition. Simply turn the control knob of the burner next to the lit
burner to HI. It will light automatically. Do not press the electronic ignition button again. Then adjust
control knob(s) to desired settings.
MANUALLY LIGHTING THE MAIN BURNERS WITH THE MATCH LIGHTING STICK
1.
Open the lid.
2.
Ensure all burners are in the “Off” position.
3.
Slowly turn on the gas at the LP tank valve if it is not already on.
4.
Place a match in the Match Holder. This is located in the top center
drawer of the grill cabinet underneath the right main burner.
5.
Use the holder to slide the lit match though the cooking grates and the
front of the heat tent to the left of the burner you wish to light.
6.
Press and turn the burner control knob to “HI/LIGHT”. Continue to push
in and hold up to 5 seconds or until the burner lights.
7.
If the burner does not light within 5 seconds, turn the burner control
knob to “Off”. Wait 5 minutes for gas to clear, and try again.
8. When lit, turn the control knob to the desired heat setting.
LIGHTING THE SIDE BURNER WITH ELECTRONIC IGNITION
1.
Open the side burner cover
2.
Ensure the side burner control knob is in the “Off” position, as well as any main burners not in use.
3.
Turn on the LP gas if it is not already on.
4.
Turn the side burner control knob to “High”.
5.
Depress the electronic ignition button and hold. You should hear a clicking sound, which shows the
electronic ignition is working.
6.
If the burner does not light within 5 seconds, turn the burner control knob to “Off”. Wait 5 minutes for the
gas to clear, and repeat the above procedure. Use the Manual directions if it still will not light.
7.
When lit, turn the side burner control knob to its desired setting.
Grill Operations
Page 27 of 33
