OutBack Power Technologies, Inc.
www.outbackpower.com 900-0120-01-00
REV
A
19009 62
nd
Ave NE
© 2011 OutBack Power Technologies
Arlington, WA 98223 USA
+1.360.435.6030
5.
Place the MATE3 against the FW-MB3. Align the four
mounting holes on the MATE3 with the FW-MB3’s
four pre-threaded inserts.
6.
Insert one 8-32 x 1¼” screw in each of the the
MATE3’s mounting holes. Turn each screw until it is
seated in the FW-MB3’s inserts. Tighten firmly with
a Phillips screwdriver.
#8-32 x 1¼”
Machine Screws
Shutter Bushing is inserted here (see below)
CONTINUED FROM PREVIOUS PAGE
Machine
Screws
7.
Line up the FW-MB3 with the opening. From
inside
the
enclosure, secure the FW-MB3 with three 8-32 x 3/8” machine
screws. Tighten firmly with a Phillips screwdriver.
NOTE
: Screws will meet some resistance when being
tightened into the FW-MB3.
8.
From
outside
the enclosure, push the shutter bushing into the
hole in the side of the FW-MB3 bracket until it seats.
Shutter
Bushing
9.
Plug the CAT5 cable into the back of
the MATE3. Follow the instructions
shown in the
MATE3 Owner’s Manual.
The MATE3 is now attached to the
FLExware assembly and ready to be used.
CAT5 Cable
