introduction
14
Carefully unpack the microwave. Remove
all packaging material and remove all
accessories from the inner chamber of the
microwave.
Carefully inspect the microwave for dents on
the body or damaged door. If you notice that
the door of the microwave is damaged, do
not install or use this microwave.
Install the microwave on a flat surface, which
provides enough space for ventilation and
opening the door.
The minimum space between the side and
rear panels of the microwave oven and the
wall should be at least 7,5 cm.
Space between the upper panel of the
microwave must be at least 30 cm.
Do not remove the legs from the bottom of
the microwave.
If there is a protective wrap, remove it
from the surface of the microwave.
Do not remove the light-brown cover
from the inner chamber of microwave it
protects the magnetron.
Blocking the vents of the microwave can
cause damage.
Install the microwave as far away from radios
and televisions as possible. Microwave can
affect their performance.
Plug in the microwave into a grounded
socket. open the door and install the roller
ring and a turntable plate, combining the
clamp on the turntable with a holder in the
center of the microwave.
Check if the turntable is installed tight: it
shouldn’t be turning freely.
Close the door and press
button.
Display will show
«
0:00
»
numbers.
Your microwave is ready for work and is
in standby mode.
INSTALLATION OF THE MICROWAVE
Summary of Contents for MD2045
