Open
Close
Off
Play
Try me
Step 1
Step 2
CAUTION:
Uses 3 x AA (1.5V) size batteries – Included
Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries. Do not dispose of this product in fire. Batteries
inside product may explode or leak.
Batteries Replacement
To replace batteries: Unscrew the battery cover
and replace 3 x AA (1.5V) size batteries.
Product is shipped in the “Try me” mode.
Slide the switch to “Play” position.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device. Under
Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the antenna type and
its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonction-
ner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans
le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il
faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonn ée équivalente
(p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autoris é e aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two
conditions : (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference thatmay cause undesired operation. Shielded
cables must be used with this unit to ensure compliance with the ClassB FCC limits. FCC RF
Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure
guidelines, place the product at least 20cm from nearby persons. The device must not be
co-located or operating in conjunction with any other antenna or transmitter. “This device
complies with FCC radiation exposure limits set forth for general population (uncontrolled
exposure). This device must not be collocated or operating in conjunction with any other antenna
or transmitter.”
Print 1 solid color PMS 676 C
Size A4: 11.69” x 8.27”
