Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
8
Using the Headset with Optional
NoizeBarrier
®
Range SA Helmet Mount Kit
(Figures 13-17)
(Parts: C102359BK, C102359FD, C102359OD,
C102365BK, C102365FD, C102365OD)
The NoizeBarrier
®
Range SA headset can easily convert
from over-the-head use to be able to mount on helmet
rails with the use of the optional helmet mounting kit. The
helmet mount kit also includes a compartment for a spare
battery on each ear cup. Follow the steps below for Team
Wendy
®
and ARC rail mount system found on Ops-Core
and other helmets.
1. Locate the lip on the headband. Pull the smaller
section away from the headband. Pull the cross-over
cable from under the lip on the headband so it hangs
free. (Figure 13).
2. Holding an ear cup with one hand, with the other
hand firmly grasp the plastic adjustment frame where
it attaches to the ear cup. Pull the adjustment frame
off the pivot point on the ear cup, being careful not
to pull on the wire form portion of the adjustment
frame. The frame will unsnap from the retention ball
on the ear cup (Figure 14).
3. Repeat the operation on the frame on the other side
of the same ear cup.
4. Repeat steps 2 and 3 on the other ear cup
to fully remove the headband.
5. Position the rail mount over the ear cup
and snap the rail mount frames onto the
pivot points on the ear cups (Figure 15).
NOTE: The spare battery compartment on
the rail mount frames should be positioned
at the top of the frame.
6. Attach the other rail mount to the other
ear cup.
7. Slide the ear cup into the top or rear rails
by inserting the tab on the back side of
the swivel base into the rail guide. The
crossover cable is routed along the rear
and the boom microphone faces the front
of the helmet (Figure 16).
8. For Team Wendy
®
and ARC rail mount system found
on Ops-Core and other helmets, remove spare
battery from the compartment, remove the helmet
mount (Figure 17).