Otto Bock Prosedo 3R31, Instructions For Use Manual

Page: 40 / 232

40
3.2 Area of application
CAUTION
Excessive strain on the product
Falling due to breakage of load-bearing components
► Use the product exclusively according to its MOBIS classification (see Fig.
4
on page 5).
► Use the product exclusively for the approved amputation levels 1 and amputation sides 2
(see Fig.
5
on page 6).
MG 1: indoor walker
The patient has the ability or the potential to use the prosthesis for the purpose of moving or proceeding
slowly on level floors. The amount of time and the distance he/she can walk are seriously limited due to
his/her condition.
3.3 Combination possibilities
CAUTION
Unallowable combination of prosthetic components
Fall due to breakage or deformation of the product
► Note that the illustrated combinations with the pictogram are permitted and those with the
pictogram are not permitted (see Fig. 6 on page 6).
► Only combine the product with prosthetic components that are approved for the patient
based on the combination table according to MOBIS (see Fig.
7
on page 7:
1
prosthetic
hip joints, 2 proximal adapters, 3 prosthetic knee joints, 4 distal adapters, 5 prosthetic
feet, 6 weight class: see instructions for use).
► Based on the instructions for use of the prosthetic components, verify that they may be com­
bined with each other.
For additional combination possibilities, please see the catalogue 646K2* or consult the manufac­
turer.
3.4 Environmental conditions
CAUTION
Use under unallowable environmental conditions
Fall due to damaged product
► Do not expose the product to unallowable environmental conditions (see the table "Unallow­
able environmental conditions" in this section).
► If the product has been exposed to unallowable environmental conditions, check it for dam­
age.
► If damage is apparent or in case of doubt, do not continue using the product.
► Take suitable measures if required (e. g. cleaning, repair, replacement, inspection by the
manufacturer or a specialist workshop etc.).
Allowable environmental conditions
Temperature range for use: -10 °C to +45 °C
Allowable relative humidity 0 % to 90 %, non-condensing
Unallowable environmental conditions
Mechanical vibrations or impacts
Perspiration, urine, fresh water, salt water, acids
Dust, sand, highly hygroscopic particles (e.g. talcum)